Brick Repair in Blaine
10 Years
Workmanship warranty, in writing
A brick in the middle of a wall shows one face. A brick at an outside corner shows two, its long face on one wall and its end on the other, and a replacement has to look right on both.
Blaine houses whose brick wraps the garage or turns in at the front entry put those corners right beside the drive. When corner units chip, crack, or flake, they are cut out and replaced with units chosen to suit both faces.
Blaine Garages Wrapped in Brick
For every Blaine home built before 1970, more than five have been built since. On the front from those later decades, brick may run across the whole face of the house or only across the garage and the entry, and either way it can turn a corner at the garage, at the edge of the entry, or at the end of a short wing beside the drive.
Those turns put corner brick at knee and shoulder height in the busiest strip of the lot, where the driveway is cleared, the bins are rolled out, and the grass is cut up to the wall. A snowblower runs along the edge of the drive, or a trimmer line runs along the base, meeting the house at its corners first, since a corner is the part of the wall that stands out into the path. The wall itself may be in good order. Our Blaine page keeps panel repair to the failed patch, and a worn corner is about the smallest patch brick repair takes on.
Wear at an Outside Corner
An edge knocked off a corner brick, with the clay behind it showing rougher and paler than the face
A crack that runs through a corner unit and around from one face to the other
A face flaked away on one side of the corner while the other side stays hard
Scrapes and gouges along the lowest corner courses, at the height of a shovel blade
A corner unit loose in its bed, or the joints at the corner worn back and open
A Brick With Two Faces to Match
Matching any replacement brick means finding one that is close in color, texture, and size, and our Minnetonka and St. Louis Park brick repair pages cover those searches. A corner adds one more condition: the end of the replacement is also shown.
Brick is made to be seen on its long face, and its ends are not always finished the same way. An end can be smoother than a textured face, or a shade apart from it, while on another brick the two agree. A corner replacement has to come from a brick whose end will sit comfortably beside the original ends running up the corner, and that narrows the field more than a replacement in the middle of a wall does.
The edge where the two faces meet is usually the most easily broken part of the unit. A knock there has only a thin wedge of fired clay to break through, so a blow that would scuff a flat stretch of wall can take the corner off a brick. Once the edge is gone, the softer clay behind it is open to water.
What the corner needs depends on the damage. A chip that takes off only the very edge and leaves both faces hard may be left alone; Sam says at the visit whether it is small enough to leave. A unit cracked through, or one with a face flaked away, is replaced, in line with our brick repair page, which rules out patching spalled brick.
Cutting a corner unit out means freeing its joints on both faces, and a slip of the blade there can mark the brick on either wall, so those joints are cut with care. Each replacement is set on fresh mortar against the corner units above and below it, and those neighbors are the guide for keeping the corner plumb. Where a run of corner units has loosened up its height, the corner is relaid as a short section instead.
If only the mortar at the corner has worn back and the bricks are still hard, they can stay, and the joints become a matter for our Blaine tuckpointing page.
Corner Repair at Published Prices
A worn corner is priced from the first two brick lines:
A corner laid in shaped units can take longer to source, and that search can move the figure. A corner loose up to its full height falls under the small wall rebuild.
Before you call
Every figure on this page depends on square footage and on what we find when we look. They are rough guides to help you decide whether to call, not quotes. The exact number comes after the visit, and the visit is free.
Chipped Corners and Car Strikes
Can a chipped corner be filled instead?+
Not by us. A filler pressed onto a broken edge covers the open clay without closing it to water, and patching broken brick is not work we take on.
A car clipped the corner. Is this the right page?+
Probably not. Damage from a vehicle has its own page, our vehicle impact masonry repair page, which covers how far a strike can reach into the wall.
Do you add corner guards?+
No, corner guards are not something we install. We replace the worn brick, and piling the snow somewhere other than against the corner spares it a good deal.
Is a corner brick a special shape?+
Sometimes. Some corners are ordinary bricks turned so that an end shows, and others are laid as shaped units with rounded or angled edges. Sam checks which at the wall, and a shaped unit further narrows the search for a replacement.
What Customers Say
What appears below is our live Google feed, not testimonials we picked out, so it shows whatever is genuinely on it.
One Shot From Each Side of the Corner
What helps on the first call:
- The face toward the drive, square on, with the damaged units in the middle of the frame
- The face around the corner, taken the same way, so the ends of the bricks show clearly